Description
Garmin 010-02735-00 Garmin Boat Switch All-In-One Digital Control
QUALITY SWITCHING. SIMPLE INSTALLATION.
Get the integrated-boat experience with digital switching that allows you to operate onboard electrical functions right from your GPSMAP® or ECHOMAP™ chartplotter.
Reduce reliance on traditional switches and fuses. Add digital control and software current monitoring.
Operate lights, pumps, horn and more. Just tap your compatible chartplotter.
Fill up or empty out? See levels in four tanks — such as fuel, freshwater, graywater, blackwater and livewell.
See system status. Monitor battery voltage, bilge pump operation and more.
Set it up your way. Position and name switches with the easy-to-use interface.
Retrofit into your boat. It requires no special tools or configuration.
ALL-IN-ONE
Replace existing two-element systems — fuse box and switches — for easier control and operation of onboard functions.
DIGITAL CONTROL
Get control and protection of up to 20 circuits via your chartplotter rather than a physical button or switch.
ON/OFF SWITCHES
The toggle outputs operate bilge pump and nondimmable lights, such as nav lights and courtesy lights.
DIMMABLE OUTPUTS
Press-and-hold dimmers let you set your preferred brightness on board.
MOMENTARY OUTPUTS
Control horns and more. Simply press and release for desired length of horn beep.
LIVEWELL TIMER
A built-in timer turns the pump to cycle the water to keep fish alive — and keep pumps functioning longer.
MONITOR TANKS
Experience built-in tank sender detection and calibration for as many as four tanks, such as fuel, freshwater, graywater, blackwater and livewell.
ADDITIONAL INPUTS
See analog voltages on house and start battery, monitor bilge pump operation, and connect optional physical switches.
UPGRADE YOUR BOAT
Retrofit into existing boats without special tools or configuration by using the included 18” flying leads and color-coded channel wires.
General
Dimensions(WxHxD) (unit only) 9.1″ x 4.2″ x 1.5″ (230 x 106 x 38 mm)
Weight (unit only) 14.1 oz (400 g)
Ambient temperature -20° C to +55° C
Enclosure water rating IP65
Communication CAN-bus NMEA 2000® network, LEN-0
Output
High side 13 ch 10A, 7 ch 5A
Digital Input
Ground contact switch input 15
Bilge pump monitor 2
Analog Input
Volt 3 @ 0-16 V +/-1%
Resistance 2 @ 0-1500 ohm +/- 5%
Power Supply
Maximum current 50A
Power off current consumption 60mA
Supply voltage (12V) 9-16VDC
Connector
NMEA 2000® Micro 5-pin M12 male
Channels Molex MX150 L 16 circuits
Power terminal M6 bolt
Reviews
There are no reviews yet.